Flexible gas stove hose 1.5 m 1/2 "EN 14800 UNIRING F / F CE Mark, hob 1/2" EN 14800 L 150 cm

Flexible gas stove hose 1.5 m 1/2 "EN 14800 UNIRING F / F CE Mark, hob 1/2" EN 14800 L 150 cm

6,51 [+22% VAT]

  € 7,08 [+22% VAT]


REQUEST COST BEFORE PAYMENT


 

RELATED PRODUCTS

 
 
 
 
 
Product code 68204
EAN 8028653682048
Category GAS HOSES
Brand MBM
Availability

Tip a friend

More questions ?

 
pin it

Flexible gas hose uniring kitchen, L 1,5 mt meter 1500 mm 1/2 "according to EN 14800, f / fa CE mark. Stovetop 1/2" according to EN 14800, L 50 cm.Istruzioni installation, use and maintenance: Installation side gas tap. in the case of tap with a female threading: banding of the thread of the tapered male fitting with teflon or similar and tighten by hand. In the case of tap with male thread: insert the gasket supplied or a norm in the tube nut and screw by hand. mounting the kitchen side: insert the gasket supplied or a norm in the tube nut and screw by hand. Place the kitchen verifying that the tube will not be twisted or crushing then proceed to the tightening of connections with wrench fixing the correct size (no parrot or pipe as crushing leads to the fitting deformation) starting, in the case, before the male fitting. check the tightness of sprinkling fittings with soapy water and then open the mural tap, in the case of formation of bubbles close the tap and check the tightness again. In the case of the pipe disassembly repeating the previous operations described above in reverse. Make sure the hose guarantees, according to the technical specifications, a range of appropriate flow, install in accordance with national and local regulations, respecting the normal rules of custom and practice. The pipe is produced according to the rules shown on the front of these instructions. Follow both these installation instructions and those of the cooking appliance manufacturers, including those for the position and orientation of the connection point as well as the creation of the earth if it is also equipped with wiring, otherwise decay immediate guarantee without any responsibility on our part for any damage that may ensue. It is prohibited to install the tube in areas with temperatures higher than 60 ° c; connect two or more pipes together; installed through walls, floors or ceilings; install upstream of the pressure reducing valve; used in case of noticeable deterioration or destruction of any part of the tube; reuse the same seal in case of disassembly (replace it every time in accordance with a); create the radii of curvature of less than 60mm.

Registered users can share their experience with this product. Register to access all of the benefits reserved to registered users or click on login if you are already registered.